Speedometer signal (ISO connector A):
Connect the black/white cable A1 from cable harness to the tapping position of the
speedometer signal. Location and connection details can be found in the vehicle
specific information sheets (available as CD ROM).
Note:
Many cars are supplied with the speedometer signal on one of the car radio
connectors. Ask your car dealer for more information or call our hotline.
A
Never tap the speedometer signal from the ABS control!
Further signals (ISO connector A):
Connect the white/yellow cable (A2) to a suitable connecting point of the back up
lights (positive pole of the reversing lamp).
Connecting system components (ISO connector B):
Connect the plug of the remote control cable to the socket on the signal cable
harness
5
.
Connect the loudspeaker (optional accessory ML 5000) with the 3.5 mm jack to the
3.5 mm plug of the signal cable harness
5
.
The loudspeaker impedance should be between 4 and 8 Ohms.
TMC extension (ISO connector C2):
For system enhancement an optional VDO Dayton RDS TMC radio or TMC receiver
MT 5000 can be connected to the navigation computer. For connection details see
“Mounting the navigation computer”.
GSM extension (ISO connector C3):
You can connect an optional VDO Dayton GSM module MG 5000 to your navigation
computer. For connection details see “Mounting the navigation computer”.
Reproduction of voice messages through vehicle speakers
For reproduction of the guidance messages by the left front speaker of the vehicle you
can connect an adaptor cable MA 1300 (optional) between the loudspeaker connector
and the audio output of the navigation computer.
Mounting the navigation computer
1. Connect the GPS antenna.
2. Connect power supply cable
6
to ISO connector A’ at the navigation computer.
3. Connect signal cable
5
to ISO connector B’ at the navigation computer.
4. Insert yellow plug C1 of the monitor cable into the left chamber of ISO connector C1’
at the navigation computer.
5. If you want to connect system extensions, take care to slide all the C plugs together
before connecting them to ISO connector C’ at the navigation connector.
Green plug C2 of the TMC extension (optional): middle part (C2) of ISO connector C2’
Blue plug C3 of the GSM module (optional): right chamber of ISO connector C3’.
6. Screw the rubber buffer onto the rear support stud of the navigation computer and
slide the computer into the metal sleeve until it clicks into position.
Caution:
First mount the navigation computer firmly, then make the connection to the
vehicle’s power supply. Otherwise a wrong calibration of the gyro sensor may result.
MOUNTING INSTRUCTIONS
50
3112 316 0888.1 Neudruck
Donnerstag, 24. August 2000 11:01:49
Farbprofil: Deaktiviert
Komposit Standardbildschirm
