INSTALLATION INSTRUCTIONS
37
English
Installing the control unit
Before installing:
Ensure suitable cable routing and that the required cable length is available.
1. Attach the control unit at a suitable point using the supplied screws. (Suitable loca-
tions could be e.g.: at the end of the centre console or behind the glove compart-
ment.)
A
Do not install the control unit near vehicle control units.
Installing the loudspeaker (ML 5000)
The loudspeaker should be installed at least 90 cm away from the microphone.
1. Unscrew the clamping screws and screw the retaining bracket to a suitable point.
2. Reattach the loudspeaker to the retaining bracket.
1
One of the vehicle loudspeakers can be connected instead of the loudspeaker, see
Connection diagram on page 4.
A
Only in conjunction with MS 3100/PC 4000 navigation system:
If a vehicle loudspeaker has already been connected to the navigation computer, the hands-
free unit must be connected to another vehicle loudspeaker via the integrated loudspeaker
crossover for optionally connecting a vehicle loudspeaker.
Installing the microphone, Fig. 2
Alignment
Fit the microphone so that the front side (the side opposite the connecting cable) is
aligned with the head of the person normally making calls in the vehicle.
The microphone should be at a distance of 20-50 cm in order to guarantee good voice
quality.
Installation
The microphone should not be installed in any areas where there are strong currents of
air.
Fit the microphone at a distance of at least 90 cm from the loudspeaker on as soft a surface
as possible in order to prevent intrinsic vibrations.
The normal installation locations are shown in Figure 2 (see arrows).
1. First clean the surface with methyl alcohol (spirit).
2. Pull the protective film off one side of the adhesive pad and secure the adhesive pad
to the back of the microphone.
3. Completely remove the protective film, position the microphone at the required loca-
tion and press it firmly into place.
MG2100_en.book Page 37 Friday, May 18, 2001 1:15 PM