Page 13 / 16
150616
■ Configure the e-mail sent and received. When there is
an alarm or the IP address of the device changes, the
receiver will receive the e-mail of the sender.
■ Note: Send alarm capture through e-mail. Check Alarm
Settings -> Mail Notification after Alarm.
■ Sender: The mailbox to send e-mails.
■ Receiver: The mailbox to receivecaptures and IP
address. Four receiving mailboxes can be set at most.
■ SMTP Server: The SMTP server to send mails.
■ Need Authentication: If the sender needs to be
authenticated, please fill in the correct username and
password.
■ Mail Test: Fill in the above mail parameters and click
“Set” for test. You can see the test result in a pop-up
window and receive a test mail in the receiving mail
box.
■ Mail Notify Internet IP Address: If this item is checked,
when internet IP or port is set, please make sure that
the port is mapped in router correctly through the virtual
server function of UPNP or router. (take an example for
the contents sent in the mail, IPCAM’s url is
http://119.123.207.96:9002)
■ Alarm Settings: Set enable alarm schedule, three alarm
methods can be enabled, namely, motion detect, trigger
detec and sound detec, it can also set the sensitivity.
Alarm Action Settings:
■ Alarm Action Settings: The actions enabled after alarm.
Record Settings
The setting page of mailbox
Alarm Settings
