vaxcommercial.co.uk
12
cleaning
How to attach hose
NOTE:
Disconnect carpet cleaner from electrical outlet.
To prevent possible leaking, remove clean solution tank by
pressing down on tank handle and pulling forward; set
tank aside (do not set tank on furniture).
Remove hose from storage rack (Fig 5/7).
Step on handle release pedal and lower deep cleaner
handle until it rests on the floor.
Unlatch back part of recovery tank and (Fig 5/8)
Remove recovery tank front panel by sliding it straight up
(Fig 5/9).
Replace panel with converter. Slide converter halfway
down opening until it is firmly in place (Fig 5/10).
NOTE:
Before connecting tube to cleaner, make sure black
tabs are extended by pulling tan collar toward tube.
Open door on hood labeled “Stair/upholstery Cleaning
Connection”. Press round solution tube connector onto
round projection inside door.
Press connector collar down firmly to ensure that it is fully
connected (Fig 5/11).
NOTE:
The tank replaces in a hinge-like manner.
Position front of lid under tabs on front of tank. Rotate lid
down onto tank.
IMPORTANT:
Make sure lid is secure on all sides
before cleaning.
For full suction, it is important that the recovery tank lid is
properly secured before cleaning. Reverse procedure to
remove hose and solution tube.
Raise carpet cleaner handle to upright position (Fig 5/12).
Fig.5/8
Fig.5/9
Fig.5/10
Fig.5/11
Fig.5/7
Handle
Front panel
Converter
Connecting tube
!
!
!
!
VCW-04 Commercial Cleaner User Guide v5.qxd:UG 27/1/09 16:52 Page 12