13
Vax Commercial Careline
0870 1129 145
cleaning
Attach tool to connector end of hose by sliding it onto
connector until the tab locks it securely.
Using your thumb, push forward and up on the latch to
remove tool as shown (Fig 5/13).
Ensure that the brush selector mode is set to the
OFF position.
Before using tool
It may be necessary to remove air from the system (“prime
the pump”) so the clean solution will flow to the tool.
Follow these steps:
Attach tool to hose and turn the carpet cleaner ON.
Put the tool on a hard surface or against your hand to
block off the suction.
Wait a few seconds (can take up to 15 seconds). Then
squeeze the trigger and begin cleaning.
Follow the instructions on page 15 for the appropriate
cleaning task.
After using tool
Follow steps a and b for “After cleaning” on page 10.
Drain suction hose by turning carpet cleaner ON and
holding end of hose up for several seconds.
IMPORTANT: Do not press trigger
.
Disconnect
carpet cleaner from electrical outlet.
Drain solution tube by placing round end in sink and raising
nozzle above your head. Press the trigger (Fig 5/14).
Occasionally, debris may become lodged inside of the hose
at the converter end.
To clean out the hose, lift bottom of converter clip with a
screwdriver and remove clip.
Remove debris as shown (Fig 5/15).
Snap clip back into position making sure solution hose is
not pinched and moves freely (Fig 5/16).
Replace recovery tank front panel.
Fig.5/12
Fig.5/13
Tabs
Tab
Latch
Fig.5/14
Fig.5/15
Converter
Converter clip
!
!
!
!
Fig.5/16
Solution tube
VCW-04 Commercial Cleaner User Guide v5.qxd:UG 27/1/09 16:52 Page 13
