www.vax.co.uk
10
7. Rotating Brushbar:
Removal and Replacement
WARNING: To reduce the risk of injury from
moving parts, unplug the cleaner before
changing belt or the rotating brushbar.
Tool required:
Phillips screwdriver
To Remove the belt
1. Lay the vacuum cleaner flat and turn it over to expose
the nozzle base. The base should lay flat and face
upwards. To remove the nozzle guard, use a Phillips
screwdriver to remove the five (5) screws. Arrows show
the location of the screws (Fig.7/1).
2. Lift the nozzle guard (Fig.7/2).
3. Lift and remove the brushbar and dispose of the belt
(Fig.7/3).
To Replace the Belt or Brushbar
1. Slide the belt onto the motorshaft (Fig.7/4). Then slide
the brushbar into the belt.
2. Place the new belt in the area of the brushbar without
bristles (Fig.7/5).
3. With the new belt in place, pull and slide the brushbar
into the nozzle, making sure that the end caps are in the
correct orientation (Fig.7/6A). Rotate the brushbar
manually to make sure the belt is properly aligned (Fig.7/6).
4. Re-attach the nozzle guard (Fig.7/7)
rotating brushbar
Fig.7/1
Fig.7/4
Fig.7/5
Fig.7/6
Fig.7/2
Fig.7/3
A
!
