7
Vax Careline
0870 606 1248
operation / accessories
when cleaning above the floor. Vax recommend that
the brushbar height adjust is turned to its highest
position when using the tools.
On/off Pedal
Plug the cord into the electrical outlet. Turn the vacuum
cleaner on by depressing the foot switch located on the
back left side of the vacuum cleaner (Fig.4/3A). The
vacuum cleaner can be turned off by pressing the on/off
switch again.
Handle Release Pedal
To release the handle, push the handle release pedal
located on the lower left side of the cleaner (Fig.4/3B).
Carpet Cleaning
Move the handle to the desired position for storage (A),
and normal operation (B). De-press the handle release
pedal again to clean under furniture (C) (Fig.4/4).
IMPORTANT: This vacuum cleaner is not
intended for use on hard floors. The powerful
rotating brush bar is designed to groom carpet pile and
could cause damage to some hard floor types.
5. Accessories
IMPORTANT: The vacuum cleaner must be in the
upright position to raise the brushbar. The
brushbar height adjust must also be at its highest
position.
1. Remove the hose from the tool caddy (Fig.5/1).
2. Choose any of the handy on-board accessories or use
the hose alone. Simply push the attachment firmly onto
the end of the extension tube or hose handle. To remove
the accessory, twist and pull apart gently (Fig.5/2).
Extension Tube
If additional length is needed, use the extension tube
and/or crevice tool. Pull the crevice tool out of the
extension tube or hose handle. To remove the tool, twist
and pull apart gently.
NOTE: The crevice tool is stored inside the extension
tube (Fig.5/3).
!
!
B
C
A
Fig.4/4
A
B
Fig.4/3
Fig.5/1
Fig.5/2
Fig.5/3
