Getting started
Fixing the wall bracket
PLEASE READ ‘LET’S TALK SAFETY’ BEFORE USE
Fully assemble the
vacuum but do not
attach the battery.
Use both screws and wall
plugs to secure the wall
bracket to the wall. Place
covers over the screws.
Attach the wall bracket
to the handle.
Firmly press the vacuum
handle into the wall
bracket to secure.
With the wall bracket
attached, stand the
vacuum close to the wall,
in the upright position
with the Powered Head
flat on the floor.
The tools and the accessory
bag can also be stored on
the wall bracket.
Holding the wall bracket
firmly in place, carefully
remove the vacuum. Using
a pencil make a small
mark for each screw.
CAUTION:
The battery used in this device may present a risk of fire or chemical burn if mistreated. Do not
disassemble or heat above manufacturer’s maximum temperature limit (60° C/140°F) or incinerate. Replace
battery with Vax battery only. Use of another battery may present a risk of fire or explosion. Dispose of used
battery promptly. Keep away from children. Do not disassemble and do not dispose of in a fire. Do not attempt to
disassemble the battery or remove any component projecting from the battery terminals. The battery and charger
have no user serviceable parts. Fire or injury may result. Prior to disposal, protect exposed terminals with heavy
insulating tape to prevent shorting. Remove the battery from the appliance before it is disposed of safely at your local
battery recycling centre.
For best performance, the terminals on both the battery and the appliance must be clean and free from dust and dirt.
Do not attempt to recharge non-rechargeable batteries. The battery must be removed from the appliance before it
is scrapped. The appliance must be disconnected from the charger before use and when removing or installing the
battery into the machine. In case of battery leakages avoid any contact with the skin. Contact our Customer Care Line
on: 0330 026 8455 (Mon-Fri 8:30am to 6:30pm, Sat 9:00am to 5:00pm).
Installing and charging the battery
Slide the battery into
the back of the handheld.
The battery will click
into position when
correctly fitted.
To charge the machine,
detach the reach wand
and lie the handheld on
its side on a flat stable
surface. You can also
charge the machine
whilst attached to the
wall mount. Make sure the
floorhead and wand are
attached together.
Insert the charger lead
into the charger inlet
located on the back of
the handle.
Plug the charger plug into
the mains.
Getting started
NOTE:
The initial charge is 8 hours, charging will be required before first use. The vacuum can be charged with
the handheld either attached to, or detached from, the reach wand. Failure to fully charge the battery before first use
(initial charge 8 hours) may result in poor battery performance.
CAUTION:
The appliance must be disconnected from the mains supply when removing the battery.
