Vauni Edge, Руководство пользователя

Страница: 32 / 56

32 |
Vauni Edge / Shadow © Copyright 2020 Vauni AB - All rights reserved
ENG
5.3 Service and maintenance
• The fireplace may be repaired only by authorized places of service.
• Fuel spillage on liner parts must immediately be wiped up with a dry rag. If this is not done, permanent
discolouring can occur.
• Maintenance according to the instructions in Section 6 must be done to ensure the fireplace’s properties
6 MAINTENANCE AND CARE
This product is designed to require a minimum of maintenance and care with normal use. If the following
instructions are followed, the fireplace will keep its properties and appearance for a long time.
6.1 General cleaning
With normal use, cleaning of the fireplace’s mantle is limited to dusting off its outer parts, which can be done
with a dry rag. If they are very dirty, a lightly moistened rag can be used, but cleaning detergents should be
avoided.
The burner and the liner parts require special care as follows.
6.2 The burner system
Since the stainless-steel metal around the burnerstrainer and the regulator lid is exposed to heat, it will
darken after some time of use, which is quite natural. However, a dark coating may appear inside the
burnerstrainer and on the regulator lid after some time of use. This must be removed regularly to ensure
optimal combustion of the fuel.
The coating is removed with the following steps:
• If the hearth has been used, it must be allowed to cool until the burner has reached room temperature.
• Remove the regulator lid by lifting it straight up.
• Scrape off any coating around or inside the burnerstrainer, using a rubber or plastic scraper. Take special
care around the burner strainer and see that no particles fall into the combustion chamber or block the
holes in the burner strainer.
• Remove the scraped-off coating by using a vacuum cleaner.
• Clean the area around the burnerstrainer with a moist rag. If it is very dirty, a mild detergent can be used
sparsely. In this case, be very careful that the liquid does not run down into the burner strainer or contact
the surrounding liner.
• Scrape off any coating from the regulator lid, then clean it off with a moistened rag. If it is very dirty, a mild
detergent can be used sparsely.
• Place the regulator lid by lowering the two guide pins into the respective grooves. When correctly placed,