Vauni Edge, Руководство пользователя

Страница: 24 / 56

24 |
Vauni Edge / Shadow © Copyright 2020 Vauni AB - All rights reserved
ENG
3 INSTALLATION
The fireplace is designed to allow flexible placement in most interiors, and requires a minimum of assembly
and installation before it can be used. To ensure that the fireplace’s full safety is utilized, it is important that
the instructions below for assembly be followed when the fireplace is installed.
Keep in mind!
The fireplace is certified to be placed in a space with a minimum volume of 32 m3 (an equivalent floor area
is 13 m2) and with normal ventilation (0.5 exchange of air per hour). It is important that the placement is
chosen so that the flame is not exposed to direct draught, and places should be especially avoided where the
draught’s direction is against the fireplace’s opening. Inflammable objects must not be placed within 1 metre
from the fireplace. Remember that curtains and similar objects must have a safety margin of at least 1 metre
due to risk of draught currents (Figure 18).
3.1 Assembly and installation
The Edge/Shadow is to a large extent assembled already when delivered and needs only minor post-assembly
and installation. Follow the steps below to assemble and install the product. Vauni recommends that the
assembly is done by two persons, since some steps require heavy lifting.
Note! Depending on the market and model variants, minor deviations may occur.
Preparations:
1. Remove the fireplace and its accessories from the packaging and check the details for possible transport
damage. Any damage must be reported immediately to the deliverer and to the place of purchase.
2. Check that all the parts and standard accessories specified in Section 2 are included.
3. Check that you have the right tools; see Section 8 Technical specifications (Figure 22).
For Edge - Mounting the front (point 4-6)
:
4. Place the front (face down) on the floor well protected with a soft surface, i e the packaging material.
Note! For Edge Stainless: Remove the protective plastic from the front after the fireplace is mounted on
the wall
5. Place the stove frame over the front. Position the six screw holes as shown in Figure 1.
6. Mount screws according to Figure 2. Make sure the screws go in straight and without much resistance. Use
an Allen wrench - tighten so that it is securely mounted. The front is now mounted - the fireplace is ready
for installation on the wall. Go to point 12.
1 2 3
X 6