Vascat MAC-HS 100, Руководство по эксплуатации и обслуживанию

Страница: 50 / 64

OPERATION AND MAINTENANCE MANUAL
MAC-HS MOTORS
PAGE: 50
CODE: CTT32 EDITION: 04 RELEASE: SEPTEMBER 2020
Subject to technical changes without prior notice
5.3.2 Start-up
WARNING
Skilled personnel
All the preliminary work must be carried out by skilled personnel and when the motors are completely stopped and isolated from
the mains. Always check that there is no voltage!
If the mains power cables are connected make sure there is no voltage and that no power voltage can be applied in any way.
PRECAUTION
Damage to the motor
Before starting up the motor, check that there are no elements blocking the rotation of the motor.
MOVING ROTATING PARTS
During start-up and while the motor is in operation, the customer is responsible for taking precaution to avoid accidental contact
with the rotating parts.
Proceed as follows to start up the motor:
1- Start-up the drive auto-tuning procedure so that it can recognise the motor (see drive documentation for more details).
2- If the auto-tuning procedure is completed successfully, start the motor rotating at low speed in both directions. Check
that the motor behaves satisfactorily and that there are no strange noises or vibrations.
3- Perform the bearings run-in according to the manufacturer's specifications or as follows:
Table 25: Grease distribution cycle for spindle bearings
4- In case of the motor remains stopped for more than 12 hours it is recommended to perform a short bearing run-in
process consisting in 3 cycles of each cycle described in the section no.3.
5- After several hours in operation, check that the thermal behaviour of the motor corresponds to the motor service type. If
in doubt, please contact VASCAT.