15 / 21
5.6.6. ID
Enter the ID address mode to set the ID address.
5.6.7. Edit custom
-
Enter the EDIT mode to edit the custom programs PR.01 to PR.10.
-
Each custom program has 30 steps that can be edited.
-
Each step allows the creation of a scene using RED 0~255, Green 0~255, Blue 0~255, White
0~255, Strobe 0~20, Time 0~255, & Fade 0~255. Then the data will be saved, when you
press the ENTER button for 5 seconds.
5.6.8. Setting
-
Select UPLD to upload the custom programs from the current MASTER unit to SLAVE units.
The SLAVE units must be set in mode RUN to Slave.
-
In order to activate the upload function the password must be entered
-
The password is the same as the main access password.
-
When uploading the SLAVE units will display YELLOW.
-
If an error occurs when uploading of the custom programs the SLAVE units will display RED.
-
On successful uploading of the custom programs the SLAVE units will display GREEN. In
order to reset custom modes to default values select: REST
-
Enter ID in order to allow/disallow ID address function from the DMX512 controller.
