![background image](http://html1.mh-extra.com/html/varian/turbo-v-150-pcb/turbo-v-150-pcb_instruction-manual_3554486065.webp)
TECHNICAL INFORMATION
59
87-900-908-01 (C)
USE
General
Make all vacuum manifold and electrical connections and
refer to Turbo-V pump instruction manual before to
operating the Turbo-V controller.
!
To avoid injury to personnel and damage to the
equipment, if the pump is laying on a table make sure it
is steady. Never operate the Turbo-V pump if the pump
inlet is not connected to the system or blanked off.
NOTE
The input signal P1 connector should be left in position
including the shipping links if no external connections
are made. The forepump and the Turbo-V pump can be
switched on at the same time.
NOTE
When the Turbo-V 150 PCB pump is baked by a
membrane pump, the Soft Start mode should be
deselected.
NOTE
The following instructions are applicable to
Turbo-V 150 PCB Controller.
Startup
•
Plug the controller power cable into a suitable
power source.
•
The display lights, and shows:
R E A D Y
F O R
L O C A L
S O F
T
S T A R T
The controller with the Soft Start mode allows the
pump to ramp-up to Normal speed slowly with a
minimum ramp-up time of 210 seconds and a
maximum of about 45 minutes.
The Soft Start mode is always operative as default
mode. If it is necessary to deselect this mode refer
to the following paragraph.
If the Soft Start mode is deselected, the ramp-up
will be done within 180 seconds and the display
changes as follows:
P U M P
R E A D Y
:
P U S H
S T A R T
B U T
T O N
•
Press the CURRENT push-button and the display
shows:
I
=
0
.
0
0 A
P
=
0 W
X
.
.
K R P M
X X
°
C
where:
•
I = is the DC current drawn by the pump range (0.00
to 9.99 Ampere)
•
P = is the DC power drawn by the pump (range 0 to
999 Watt)
•
KRPM = is the theoretical rotational speed of the
pump as a function of the controller output
frequency (range 3 to 62 KRPM)
•
°C = is the temperature of the outer ring of the
upper bearing (range 00 to 99 °C)
•
X = during operation a selected set point condition
(1 or 2 contrast inverted) appears when the
programmed threshold speed value is not reached.
WARNING!
Содержание Turbo-V 150 PCB
Страница 2: ...Turbo V 150 PCB Controller...
Страница 3: ......
Страница 4: ......
Страница 76: ...TECHNICAL INFORMATION 70 87 900 908 01 C...