Vari Lite VL3015, Руководство по обслуживанию

Страница: 55 / 210

M
AINTENANCE
P
ROCEDURES
: P
AN
M
OTOR
A
SSEMBLY
/P
AN
B
ELT
R
EPLACEMENT
0 2 . 9 6 7 9 . 0 0 1 0 0 37
2
WARNING: You must remove all power from luminaire before performing maintenance. Fixture
may be very HOT after operation. Allow it to cool completely before performing any maintenance.
Step 3. At each top enclosure cover, remove two 6-32x1/4" PPB screws and remove cover.
Step 4. Disconnect the following cable assemblies:
a. Disconnect lamp wire from J202 and J203.
b. Disconnect DC wire from LVS.
c. Disconnect DMX wire from DMX PCB.
d. Disconnect Display wire from Display.
e. Remove ground wire from chassis.
Step 5. Remove pan motor assembly. See “To remove and replace pan motor assembly / pan belt:”
on page 36.
Step 6. Pass wire through routing hole in chassis
Step 7. Remove belt.
Step 8. Replace by performing previous steps in reverse.
Note: Make sure wiring is not pinched during installation. When tightening four 10-32x3/4" SCB Cap
screws that mount Pan Motor Assembly, you must tighten in a CLOCKWISE pattern starting with
screw in lower left-hand side from spring.
Figure 2-16: Pan Motor Assembly Replacement
Bottom Cover
Head not shown for clarity.
NOTE:
Pan Belt
Pan Motor
Assembly
Enclosure Bottom View