18
On the bottom side of the top cap you can see the mesh clamp ring which holds the upper mesh of the
filling chamber. Use the supplied 1.5 mm Allen wrench to get into one of the holes of the mesh clamp
ring. The ring is unscrewed and the upper mesh of the filling chamber can be replaced.
Use only original Vape Engineering parts. Meshes are available as accessories.
Once the new mesh is inserted into the top cap, the mesh clamp ring can be screwed back in using the
1.5mm Allen wrench. Then the top cap is mounted again on the housing.
Now connect the vaporizer to the box mod again.
8.7
Heating up
The HERBIE evaporator is an on demand Vaporizer. The Vaporizer does not require any heating time.
The vaporizer must never be used without airflow, as there is a risk of burning the material
to be vaporized. This means that as soon as the vaporizer is in operation, you must pull on
it to ensure an airflow.
9
Application
When using HERIE in wattage mode, start at a low wattage such as 30 watts (on the included mesh)
and go up 2-3 watts at a time until you feel the ramp up speed of the heater is optimal. Since the box
mod is not calculating temperature in wattage mode, vapor is produced by balancing the heater’s ramp
up speed (determined by wattage) with the users inhale speed. This technique takes a bit of practice
to master, but can produce powerful results. After 5-7 seconds, a steady stream of vapor will begin to
become more and more thick, at which time the user can either speed up their draw to decrease the
ramp up in vapor and avoid combustion, maintain their inhale speed, or slow their inhale speed to
allow vapor to ramp up faster. Experiment with different wattages, different resistance of the heat
mesh, airflow configurations, and inhale speeds to achieve best results. Find your personal sweet spot.
