15
Tip:
If the Filling Chamber is only partially filled, then the vaporization material may shift
around; the hot air then bypasses the vaporization material, so that no vaporization can
occur.
If the filling chamber should not be completely filled, we recommend the Vape Engineering chamber
reduction. This is available as an accessory.
Take care that the meshes are not obstructed with plant material. To guarantee optimal results, we
recommend cleaning the meshes after each vaporization cycle with the enclosed cleaning brush. The
upper mesh especially can become clogged with plant material and so make inhaling difficult. In this
case, remove the Screen as described in Chapter. “Replacing the upper mesh”.
Then screw the top cap of the Vaporizer back on. As soon as the lower filling chamber mesh is clogged
or deposits appear on the filling chamber walls, the filling chamber must be cleaned. After cleaning, a
new mesh must be inserted.
8.4
Adjusting the airflow
After the HERBIE Vaporizer is installed on the box mod, rotate the housing of the Vape Engineering
HERBIE in any direction to adjust the airflow. The less of the intake ventilation visible, the more
restricted the draw will become and vice versa. A more restricted draw results in denser and slightly
hotter vapor whereas wide open airflow will have cooler but more airy vapor. You can adjust the
airflow between draws to your preference.
CAUTION!
Never use the Vaporizer with the ventilation completely closed. This leads to a
combustion of your plant material.
Fully open ~ 1/3 open
