www.fmiproducts.com
113110-01K
24
OPERATION
Continued
Figure 36 - Setting the Selector Switch,
Control Knob, and Flame Adjustment
Knob for Hand-Held Remote Operation
OFF
P
IL
O
T
LO
IH
REMOTE
OFF
ON
ON
Flame
Adjustment Knob
Control Knob
Selector Switch in REMOTE Position
(Optional Hand-Held Remote Control)
3. To shut off burners only and keep pilot
lit, you can turn control knob clockwise
to PILOT position, use remote
control manual OFF button, or set selector
switch in OFF position.
Shutting Off burners Only (pilot stays lit)
You may shut off the burners and keep the
pilot lit by doing one of the following:
1. Turn control knob clockwise
to the
PILOT position.
2. Use remote control manual OFF button.
3. Set selector switch in the OFF posi
tion.
MANUAL LIGHTING
PROCEDURE
1. Follow steps 1 through 6 under
Lighting
Instructions
, page 22.
2. Depress control knob and light pilot with
match.
3. Keep control knob pressed in for 30
seconds after lighting pilot. After 30 sec-
onds, release control knob. Now follow
steps 9 through 11,
Lighting Instructions
,
page 22.
OPTIONAL HAND-HELD
REMOTE OPERATION
Note: All remote control accessories must
be purchased separately (see Accessories,
page 33). Follow instructions included with
the remote control.
NOTICE: You must light the pilot
before using the hand-held re
-
mote control unit. See
Lighting
Instructions
on page 22.
After lighting, let pilot flame burn for about
one minute. Turn control knob to ON position.
Adjust flame adjustment knob anywhere be
-
tween HI and LO. Slide the selector switch to
the REMOTE position (see Figure 36).
Note: The burner may light if hand-held re-
mote was on when selector switch was last
turned off. You can now turn the burner on and
off with the hand-held remote control unit.
IMPORTANT
: Do not leave selector switch in
REMOTE or ON position when pilot is not lit.
This will drain the battery.
GWMT1 WALL MOUNTED
THERMOSTAT (OPTIONAL)
Make sure heater switch is on AUTO and set
temperature adjustment on wall thermostat
to desired setting. Thermostat has been
electronically calibrated at the factory and
requires no adjustment or leveling.
Upon installation, thermostat must be allowed
to stabilize at room temperature for a minimum
of 30 minutes for proper operation. See installa-
tion instructions on page 20 of this manual.
GWMS2 WALL MOUNTED
SWITCH (OPTIONAL)
Make sure heater switch is on AUTO. This wall
switch works just like the conventional light
switch. Flip switch up for on and down for off.
Note: Make sure that this switch is not in a
position to be mistaken for a light switch. This
may result in fireplace being inadvertently
turned on without proper precautions being
taken. See installation instructions on page
21 of this manual.
OPERATING
bLOWER (OPTIONAL)
This blower has three settings: ON, OFF, and
AUTO. In ON position, blower will operate
constantly. In OFF position, blower will not
operate. In AUTO position, blower will start
when thermostat senses a sufficient increase
in firebox temperature.
Note: Your fireplace and thermostat blower
will not turn on and off at the same time.
Fireplace may run for several minutes before
blower turns on. After heater modulates to
pilot position, blower will continue to run. The
blower will shut off after firebox temperature
decreases.