www.vanco1.com
800.626.6445
7
CONNECTION DIAGRAM
BluRay® Player
HDTV
HDMI
HDMI
IR Transmitter
IR Receiver
IR Transmitter
IR Receiver
HDMI over Coax Cable
Transmitter
Front
Back
Front
Back
Receiver
CONNECT AND OPERATE
1.
Connect a source such as a Blu-Ray Player, game console, A/V Receiver, Cable or
Satellite Receiver, etc. to the HDMI input on the Transmitting unit.
2.
Connect a display such as an HDTV or HD Projector to the HDMI output on the
Receiving unit.
3.
Connect a single RG6 or RG59 coaxial cable to the “COAX OUT” connector of the
Transmitting unit, and then to the “COAX IN” connector of the Receiving unit.
4.
For power, plug in the Transmitting and Receiving units with included DC 5V 2A power
supplies.
5.
Power on each device in the same sequence (receiver and transmitter will already be
powered when either unit is plugged in.)
At this point the display connected should display the source signal connected to the extender set. If no signal
is being displayed, check coax cables and connections. If a display is having difficulty receiving a signal, see
EDID section and perform EDID learning or access the display’s menu and adjust the resolution (lowest to
highest until signal is displayed). A 24 Hz vertical refresh rate may work better than 60 Hz or higher. Use the
source remote at the receiver emitter to test IR functionality. If the IR remote function is not responding,
check the emitters to ensure they are placed correctly and are plugged into the correct IR jacks on the
Extender set receiving and transmitting units.
