www.
vancare
.com
15
Cleaning and Disinfection
The exterior of the
G-Series Lift
should only be cleaned, disinfected using the recommended cleaning agents shown
below. Damp a cloth with the cleaning agent and wipe down entire exterior of the lift and carry bar. Other chemicals
and/or liquids not listed should not be used to clean and disinfect this lift.
Take great care to ensure that no liquids get inside the
Vancare
G-Series Lift.
The lift is not drip proof or
water tight. Failure to protect the lift from liquids may result in damage to the lift and may cause personal
injury.
Recommended cleaning agents:
•
Virox Accel TB
•
Virox 5
•
Dispatch Hospital Cleaner disinfectant towels with Bleach
•
Clorox Healthcare Professional Disinfecting Bleach Wipes
•
Sani-Cloth super germicidal disposable wipes
•
Virocidin-X
Troubleshooting
Should problems arise with the use of the
Vancare
G-Series Lift,
review the following chart. Find the fault and
complete the recommended solution. If the fault is not found and or/the solution does not correct the problem
contact
Vancare
.
Fault
Recommended Solution
The
G-Series Lift e
mits a slow beep while in use. The
lift only goes down but not in the upwards direction.
The batteries are low and the lift should be charged.
The
G-Series Lift motor
cannot lift.
If the load is in excess of the safe working load the
G-Series Lift
will
not work due to over-current protection.
The batteries are always dead after a few charges
Replace the batteries as they may be at the end of their service life
The
G-Series Lift
does not operate when you
press the buttons on the hand control.
Check that the emergency cord is not pulled.
The
G-Series Lift i
s not operating properly
Make sure the
G-Series Lift
is inserted all the way inside the
trolley. This would activate the trolley's limit switches.
The lift does not go up
There may be a twist in the lift strap.
