12
Vancare
The
Vancare
G-Series Lift
is switched on automatically when a button on the hand control is
pressed.
The
Vancare
G-Series Lift
switches off automatically after approximately three
minutes without activation.
Charging the
G-Series Lift
The charger contacts with two metal charging strips located inside the track.
Whenever the lift is over a section of track with charging strips, it will automatically
start to charge the lift if the battery is low.
The batteries should be charged on a regular basis. It is recommended that the lift be
left on charge when not in operation, and at the end of each day. This will maximize
the life cycle of the batteries.
The
G-Series Lift
may remain connected to the charger indefinitely since the
charger has a built-in regulator, eliminating the danger of overcharging.
As a general rule, it is recommended that the carry bar be raised to a height that will not interfere with anything or
anyone while the lift is not in use.
!
Do not drain the batteries excessively. This will dramatically reduce the lifespan of the batteries. If the slow
beep sounds, be sure to recharge the battery as soon as possible.
!
Do not leave the
G-Series Lift
with the power on for a long time. If the
G-Series Lift
is not returned to the
charger the
batteries will be drained and damaged.
!
Do not install the power supply in a position where it is not possible to disconnect the plug from the charger.
NOTE: Ensure that the trolley is in the charging section of the track when installing the lift.
Operating the
G-Series Lift
"DOWN" button
"UP" button
