10
Vancare
nstallin t e
G-Series Lift
in t e Vancare
Trac
3. By using an adjustable wrench, remove the end stopper on the
PLP track by loosening the bolts.
4. Slide the
G-Series Lift
motor into the PLP track from the
other
side.
Make sure the
G-Series Lift
Motor is constantly in
contact with the
charging strip.
5. Fasten the end stops back on to the PLP track. Ensure there is enough clearance room to
place the end cap on the PLP arm and place the end cap back on the arm.
6.
Fasten all end stops tightly using an adjustable wrench.
!
NOTE: If you are installing the
Vancare
G-Series Lift
in an existing track system you must ensure that the
max load
of
the track system is equal or higher than the max load of the
Vancare
G-Series Lift.
7. To disconnect the lift from the trolley, press on the two quick release trolley buttons and
pull down on the lift.
Charging Strip
