VAN WAMEL Perfect ZF2, Руководство пользователя

Страница: 10 / 59

8
disengaged, the motor shut-off and the tractor key is pulled out.
14.
The disconnected P.T.O. shaft must by ‘stored” by the corresponding chain.
15. After you have disconnected the P.T.O. shaft you must replace the tractor P.T.O. shaft cover directly
1.2.3 Service
1. During adjustment-, cleaning- and service-work, but also when you have to remove an object out of the machine
you must disengage the tractor P.T.O. shaft, shut-off the motor and pull the tractor key out.
2. Check at regular times (at least every 8 hours) all bolts and nuts. Re-tight them if necessary.
3. Use adequate supports when you have to work under a lifted machine.
4. Use always the correct tools and wear gloves when you replace flails.
5. Collect used and excess oil and grease for environment friendly disposal.
6. Check at regular times (at least every 8 hours) the condition of the protection elements and wear-off parts. Replace
them if necessary.
7. Disconnect the dynamo ánd the battery during electric welding-work
8. Re-placement parts must comply at least the manufacturer specifications.
You do not have doubts when you use original Perfect parts !!!
1.3 Technical Information
ZF2-150 ZF2-180 ZF2-210 ZF2-240
Cutting width cm 150 180 210 240
Speed flail omw./min. 2225 2225 2225 2225
Number of flails n 16 18 22 24
Minimum tractor power kW/hp 44/60 50/68 55/75 65/88
Maximum tractor power (without clutch)
kW/hp 75/100 75/100 75/100 75/100
Cutting height cm 4
–
9 4
–
9 4
–
9 4 - 9
Coupling Kat. II II II II
Offser to the rechts (from center of tractor) cm 325 355 385 415
Machine width cm 175 175 175 175
Cutting height (with cutting height of 45mm) cm 48 48 48 48
Machine length (from pen lift arm) cm 122 122 122 122
Machine weight kg 915 965 1025 1095
1.4 Putting in service of a unit
During road-transport the machine is carried by the tractor 3-point linkage.
It is not allowed to carry the machine in offset position during road-transport !
The machine is supplied from the factory without oil in the hydraulic hoses and cylinders, when it is
delivered with
the option “hydraulic offset”. Be sure when first time using that no
air left in the hoses
and cylinders.
1.4.1 Fitting to the tractor
While the mower is coupled to the tractor nobody should stand in
between the tractor and the machine.
1.4.1.1 Mechanically
The ZF2 mower is coupled to the tractor with the pins, Cat. II. Secure these pins
with the corresponding spring locks.
The top link pin, at the mowers side, should always be put in the round hole on
top of the 3-point bow!
The pull cord of the transport safety lock, should be secured properly in the
tractor cabin.