Assembly & Installa
Ɵ
on Guide
EASI-LOAD 3 - SINGLE LADDER KIT
REF: 699-0777-07a
EASI-LOAD 3:
SINGLE LADDER KIT
CUSTOMER SERVICE AND TECHNICAL SUPPORT
TEL: 0800 107 0003
E-MAIL: [email protected]
A:
B:
LOCATE x6 SLOT WASHER ASSEMBLIES INTO EACH EASI-LOAD BASE UNIT CHANNEL AS SHOWN.
2
LOCATE A M8 x 25mm COACH BOLT (12) INTO SLOT WASHER (9) AS SHOWN, x12 REQUIRED.
LOCATE EASI-LOAD SYSTEM ONTO PREFITTED CROSSBARS ON VEHICLE ROOF, THIS IS A x2 PERSON PROCEDURE.
IF EASI-LOAD DOES NOT SPAN THE REQUIRED DISTANCE, WHERE POSSIBLE ADJUST LOCATION OF CROSSBARS
1
DETERMINE CONFIGURATION OF CROSSBARS THAT WILL BE USED TO SECURE EASI-LOAD AND PROCEED ONTO STAGE 4.
3
LOOSELY ATTACH EASI-LOAD SYSTEM ONTO ALL RELEVANT VEHICLE CROSSBARS USING THE TYPICAL FIXING METHOD SHOWN ABOVE.
IMPORTANT: ATTACH USING SEQUENCE DETAILED AND ENSURE SYSTEM IS STABLE BUT LOOSE ENOUGH TO SLIDE.
4
PHASE 2: INSTALLATION OF EASI-LOAD SYSTEM
LOCATE EASI-LOAD
ONTO VEHICLE ROOF
HANDLE AT REAR
9
x12 REQUIRED
12
EASI-LOAD SYSTEM MUST BE SECURED ONTO THE VEHICLE AT A MINIMUM OF x3 CROSSBARS
PLEASE REFER TO STAGE 3 DIRECTLY BELOW FOR COMMON CONFIGURATIONS
DETERMINE CONFIGURATION TO BE USED AND PROCEED ONTO STAGE 4
IMPORTANT
7
9 & 12
VEH
ICLE CR
OSSB
AR
14
15
x6 EACH SIDE
x2 CROSSBARS
NOT ADEQUATE DO NOT FIT
x3 CROSSBARS
SECURE ONTO ALL
CROSSBARS
x4 CROSSBARS
SECURE ONTO CROSSBARS
INDICATED
x5 CROSSBARS
SECURE ONTO CROSSBARS
INDICATED
LOOSELY ATTACH BUT
ENSURE SYSTEM STABLE
1
st
2
nd
3
rd
ATTACH ONTO CROSSBARS
IN SEQUENCE ABOVE
