ELECTRIC BICYCLE METER KT
—
LCD7 Product User Manual
- 19 -
P5 is power monitoring setting, when P5 setting is 0, the power monitoring is the
"
real-time voltage
" mode. Namely, it is the method to determine the battery capacity
based on real-time battery voltage. When P5 equals to a specified parameter, the power
monitoring is the "
smart power
" mode (this parameter is determined by the battery
characteristics, ordinary 24V lithium is generally is 4-11, 36V lithium is between 5_15). P5
setting ranges from 0-40, hold
button (
UP
) or
button
(DOWN)
shortly for
selection. P 5 parameter setting method is the same to that of P2.
After finishing P5 parameter setting, hold
button (
SW
) shortly to save current
set the values, and then P5 parameter column stops flashing. Hold
button (
SW
)
shortly again, the meter re-enter P1 parameter setting interface. Or hold
button (
SW
)
long for about 2 seconds to exit P parameter setting environment and return to the display
1.
○
Exit P Parameter Setting
Among the five P parameter settings, when each parameter setting is completed, if
held
button (
SW
) long for about 2 seconds, all can exit the setting environment and
return to display 1, meanwhile, the current set parameters would be saved.
Under each parameter setting interface, if there’s no button operation on the meter for
more than 1 minute, and then the meter will automatically return to display 1, and the
original set parameters will be saved.
C Parameter Setting
After finishing P5 parameter setting, P5 parameter column stops flashing. Within 1
minute after stopping flashing, hold
button
(UP)
and
button
(DOWN)
for
about 2 seconds to enter C parameter setting environment.
○
C1 Power-assist Sensor and Parameter Selection Setting
Set C1 parameter first after entering C parameter setting environment, C1 parameter
column and PAS sign flashes.
