Valsi G120MG2200RV, Руководство по сборке и эксплуатации

Страница: 9 / 24

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
9
5
6
1
2
3
4
qUICK STARTING TIPS FOR UNITS THAT
HAvE BEEN SITTING FOR A WHILE
If your unit has not been used for a long period of time
and it is hard to start it, try to do some of these easy
steps before calling the customers hotline.
Check the oil level.
Replace the old fuel.
Change the spark plug.
Check the fuel lines. Make sure the fuel valve is open.
Check all generator parts for integrity
Clean the carburetor. (See engine manual for service
centers)
1
2
3
4
5
6
Before each use, review the general conditions for the
generator, review that all the pieces are complete, review
if there are damaged cables or some other condition that
can affect that the generator operates on safe way. If a
strange noise is listened to or some abnormal vibration,
turn off the generator immediately. Be sure to fix the
problem before giving the generator more use. Do not
use the equipment damaged.
Periodically inspect all the screws and bolts to check
they are in place and tight.
Keep this equipment in a clean and dry place.
For the best maintenance of the engine and any other
problem, read the engine owner’s manual.
After the engine has become cool, remove the excessive
gasoline and store it in a container, safe and approved
for that purpose.
After the first 20 hours of use of the generator drain and
replace the oil of the engine, after that the oil must be
changed every 100 working hours
HEAT SHIELD:
Inspect to ensure that all heat shields and heat deflectors
are intact and in place. Removing of these parts could
cause serious damage to the unit.
ENGINE: Carburetor Icing
During the winter months, rare atmospheric conditions
could cause an icing condition in the carburetor. If it
happens, the engine may run rough, loose power, and
may stall. Call Product Service for more information.
NOTE: Refer to the engine manufacturer’s manual for
service and maintenance of the engine.
SERvICE AND STORAGE
INFREqUENT SERvICE
If the unit is used infrequently, difficult starting may result,
to eliminate hard starting, run the generator at least 30
minutes every 15 days. Also, if the unit will not be used
for some time, it is a good idea to drain the fuel from the
carburetor and gas tank.
LONG TERM STORAGE
When the generator set is not being operated or is being
stored more than one month, follow these instructions:
Replenish engine oil to upper level.
Drain gasoline from fuel tank line and carburetor.
Pour about one teaspoon of engine oil through the spark
plug hole, pull the recoil starter several times and replace
the plug. Then pull the starter until you feel piston is on
its compression stroke and leave it in that position. This
closes both the intake and exhaust valves to prevent the
inside of cylinder from rusting.
Cover the unit and store in a clean, dry place that is well
ventilated away from open flame or sparks.
NOTE: We recommend always using a fuel stabilizer.
A fuel stabilizer will minimize the formation of fuel gum
deposits during storage. The fuel stabilizer can be added
to the gasoline in the fuel tank, or into the gasoline in a
storage container.
1
2
3
4
THE MANUFACTURER AND/OR DISTRIBUTOR HAS
PROVIDED THE PARTS DIAGRAM IN THIS MANUAL
AS A REFERENCE TOOL ONLY. NEITHER THE
MANUFACTURER NOR DISTRIBUTOR MAKES ANY
REPRESENTATION OR WARRANTY OF ANY KIND
TO THE BUYER THAT HE OR SHE IS QUALIFIED TO
MAKE ANY REPAIRS TO THE PRODUCT OR THAT
HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS
OF THE PRODUCT. IN FACT, THE MANUFACTURER
AND/OR DISTRIBUTOR EXPRESSLY STATES
THAT ALL REPAIRS AND PARTS REPLACEMENTS
SHOULD BE UNDERTAKEN BY CERTIFIED AND
LICENSED TECHNICIANS AND NOT BY THE BUYER.
THE BUYER ASSUMES ALL RISK AND LIABILITY
ARISING OUT OF HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT PARTS
THERETO, OR ARISING OUT OF HIS OR HER
INSTALLATION OF REPLACEMENT PARTS THERE
TO.
READ THE FOLLOWING CAREFULLY