![background image](http://html1.mh-extra.com/html/valore/vlt-e36as/vlt-e36as_use-care-and-installation-manual_3317340011.webp)
9
1
2
Ceiling Joists
Wood Blocking
Top Support Frame
Support Frame Arm
Bottom Support Frame
Hood Body
Blower Housing
3
Mounting Screws
(pre-installed)
4
Installation –
Mounting the Hood
1. Determine mounting location on ceiling and temporarily tape paper template (included with the hood) to the ceiling.
Cut out internal shaded area of template to allow the ducting and electrical to pass through. If necessary, add Wood
Blocking (min. 2” x 4”) to ceiling joists located behind the drywall to reinforce the mounting location*. (FIG. A1) Secure
(2) M6 x 1-1/2” wood screws to points A and B of the paper template (FIG B). Do not completely tighten screws, leave
approx. 1/4” exposed.
2. Remove screws securing top and bottom support frames together. Adjust support frame to accomodate the desired
hood height and re-assemble the frame using the previously removed screws (2 for each support frame arm). (FIG. A3)
3. Lift support frame assembly up to the ceiling making sure the word “front” on the top support frame faces the front of
the hood where the controls will be located. (FIG. D) The key holes on the top support frame should cover the wood
screws previously installed in the ceiling. Slide support frame towards narrow end of key holes to lock the frame in
place. Install the last (2) M6 x 1-1/2” wood screws with washers into the two remaining corners of the top support frame
to secure it to the ceiling. Tighten all screws.
4. Lift hood and align the (4) pre-installed mounting screws located on top of the Blower Housing (FIG. A4) with the (4)
key holes on the Bottom of Support Frame. (FIG. C) Slide hood towards the narrow end of key holes to lock into place.
Hand tighten each of the (4) screws with a screwdriver to secure hood to Bottom Support Frame. Further secure
bottom support frame to unit body by one M4 x 12 safety screw. (FIG. G, pg 10)
*Hood is intended to be mounted to a fi nished ceiling.
CAUTION: At least two installers are
required due to the weight and size of the
hood.
!
Bottom Support Frame
(secures to top of blower housing)
Key Holes
front - facing controls
back
FIG. A
FIG. C
FIG. D
Top Support Frame
Side
Front / Back
FIG. B
Содержание VLT-E36AS
Страница 2: ......
Страница 18: ...16 Wiring Diagrams...