Note: Before drilling, ensure you have the correct
bit for your shower surface.
• Use the correct drill bit indicated in the diagram
8 to drill the holes you marked earlier.
Only drill 1.5 maximum to fully enclose the
"
anchor screws.
•
Note: Check to ensure there is no existing
water pipes or obstruction behind the area
you are drilling.
If there is an obstruction, you will need to
reposition the template guide to avoid it.
• After holes have been drilled, insert the
provided Anchor Screws (Part #15).
• To ensure the template (and your shower panel)
will be in a completely straight and level position,
use a level tool against the side of the template
guide to make fine adjustments to the template
guide's position until fully level.
• Once fully level, this will be the final position of
the template guide.
• Take a pencil/marker and mark the positions of
the anchor screws (Part #15) for which 4 holes
will need to be drilled.
• Remove installation template once holes has
been marked with a pencil/maker.
8
INSTALLATION INSTRUCTIONS
- 9 -
15
x4PCS
10
9
Hole
dia=φ0.256"
D
"
epth=1.2