• Before Installation, ensure there is sufficient
clearance to accommodate the shower panel.
A minimum of 19.5” is required between the
shower outlet and top of your existing valve.
Maximum clearance required 42”.
Ensure that the water line to the overhead
shower pipe is completely shut off prior to
performing any work.
• Remove your existing shower head.Then
remove your existing shower arm
INSTALLATION INSTRUCTIONS
- 6 -
- 7 -
3
4
4
MAX
5/
8"
Flow Regulator
17
W
ater Flow
O Ring
M
in 1
9
.5 I
n
c
h
accommodate the shower panel's
Brass Extender Joint (Part #4)
½
" diameter is needed to
4
• Two brass extender joints (Part #4) are included
with this shower panel.
Test both extender joints to see which joint will
provide you a minimum of 5/8'' from the wall.
• Use the plumbing tape and wrap the threaded
part of the brass extender joint (Part #4) on
both ends.
• Place the flow regulator (Part #17) into the
appropriate extender joint (Part #4), ensure the
flow regulator's direction is right as diagram 4
indicating, ensure the longer end of threading
on the extender joint is facing outward.
Note:
T
he flow regulator (Part #1
7
) is required
to be installed as some states in the U.S.
require a flow rate of 2.0GPM . You can
choose to install the flow regulator based on
the requirements of state or local plumbing
codes.
Note: California users has flow regulator
installed already
1
