START USING THE WIRELESS EARPIECE
1) Charging the earpiece (1.0A USB adapter to wall plug)
Plug the micro USB cable into the charging port located at the back of the docking station and
connect it to a USB adapter (1.0A) to a wall plug. To fully charge the earpiece, place it on the
docking station to be fully charged for at least 2 hours.
The LED indicator of the wireless earpiece will turn solid Red when charging and turns off
upon fully charged. The LED indicator of the docking station will turn solid Blue.
When the LED indicator of the wireless earpiece turns from Blue to flashing Red, it means
that charging is required.
Note: Please charge the earpiece for at least 8 hours before first use. Make sure that the wireless earpiece is
turned off before charging for the first time.
2) Turning ON the earpiece
Push the switch upwards to the ‘ ’ icon to turn on the earpiece and the LED indicator of the
earpiece will flash Blue three times.
Once turned on, there will be a voice prompt playing, “Power on”.
3) Pairing the wireless earpiece (switched off)
Step 1: Turn on the wireless earpiece.
Step 2: Press and hold the ‘Multifunctional’ button of the earpiece until the LED light flashes
Blue & Red alternately (about 4 seconds).
Step 3: Activate Bluetooth function on your mobile phone to begin pairing with earpiece.
Step 4: Connect to the earpiece by selecting ‘Valore BL-V1’ under the device list.
Note: If the pairing is not successful, please turn off wireless earpiece first, and then re-pair again. After pairing
is successful, paired devices will remember each other.
Unless pairing information is deleted because of new pairing, no need to pair when using the next time.
4) Re-pairing the wireless earpiece
Each time the wireless earpiece is turned on, it will attempt to connect to the last device it was
paired with automatically (mobile phone with Bluetooth function turned on).
The wireless earpiece will do as follows:
1. Connect to last connected devices automatically;
2. Be listed in the screen of devices as an output channel. Select ‘Valore BL-V1’ to connect.
Note: In some cases, the earpiece may need to be manually selected from your operating system sound or
hardware output list.
