Valor Vogue 1300IRN, Инструкция по установке и эксплуатации

Страница: 33 / 46

33
Owner’s Information
Batteries
Low battery signal: see page 38.
BEFORE changing the batteries, turn off the valve using
the manual On/Off switch — see instructions next page.
The appliance uses four 1.5 V AA alkaline batteries for
its remote control receiver and one 9 V alkaline battery
for its handset. Batteries should last one to two seasons,
depending on usage. Removing the batteries in the off-
season will extend the battery life. Should the batteries
lose power, the control may be operated by manually
turning the control knob at the valve or by turning off the
valve at the switch.
To replace the batteries in the remote control
receiver :
1. Appliance fitted with Four-Sided Trim or no trim:
Remove both side access panels, the window, and the
plinth.
Appliance fitted with Three-Sided Trim 1335: Open
the left side access panel.
2. The receiver is located at the left of the fireplace,
under the valve. Pull the receiver out carefully.
3. Slide and remove the receiver cover.
4. Replace the 4 AA batteries.
5. Replace the cover.
6. Put the receiver back on its plate. If it was unhooked,
replace the antenna in its clip. IMPORTANT: The
antenna MUST NOT TOUCH the ignition wire to
avoid a short-circuit.
7. Replace the window and plinth if removed, and close
the side panel.
Servicing
If any attention is required for your appliance, contact
your supplier quoting the model number. It will be helpful
if the appliance serial number can also be quoted. This
number is on the rating plate, which is located on the
firebox left hand side panel behind the valve assembly.
Open the left hand side door to see it. The replacement
parts are shown at the end of this manual. Please always
quote the part number and description when requesting
spare parts.
If the antenna was
unhooked when
replacing batteries,
hook it back to its
clip.
NOTE: It MUST
NOT TOUCH the
ignition wire!
Antenna
Ignition Wire
!
CAUTION
DO NOT USE a screwdriver or other metallic object to
remove the batteries from the receiver or the handset!
This could cause a short circuit to the receiver.
CAUTION
To avoid short-circuit to the receiver, position the an-
tenna so that it DOES NOT TOUCH the ignition wire.