4
Injector Elbow
Reinstall the main burner injector elbow—see fi gure
3. Ensure the proper injector for the desired fuel type.
Note the catalogue number from the
Specifi cations
table on page 1 and the same number stamped on the
side of the injector elbow.
•
If converting to a LPG burner, DO NOT reinstall the
air shutter.
•
If converting to a NG burner, install the air shutter
supplied with this kit as shown in fi gure 3.
Pilot Injector
1. Remove the pilot hood by pulling on it.
2. Unscrew the pilot injector using an Allen key. Discard
the pilot injector.
3. Replace with the appropriate pilot injector—see
Specifi cations
table on page 1. Screw the new
injector.
4. Refi t the pilot hood by pushing down on it.
Figure 4
Install air shutter on
NG units only
Re-install
log retaining
bracket
Thread injector
elbow through
air shutter (if
used) into end
of burner
Reconnect to pipe and
ensure it is gas-tight
Install air
shutter
slider (NG
units only)
Suggested air shutter
setting (NG units only)
Tighten screw
with slider at
mid-point in
slot
Insert air
shutter
tab into
top hole
of slider
Suggested NG
air shutter setting
Figure 3
