Packing Contents:
1 Wall Bracket A
2 Screws B
1 Screw C
2 Wall Anchor D
1 Spacer E
(detach before assembly)
1 Wall Bracket F
Switch Plate
Alternative 1
Alternative 2
Alternative 3
Open
Open
Close
Close
Natural gas
Flashback shield
(for propane gas
only)
Air Shutter Slider
(propane gas)
Open
Close
Propane gas
Air Shutter
Slider & Cover
(natural gas)
Install Handset Wall Holder
The remote control kit for this
fi
replace
comes complete with a wall-mounted holder.
This holder is not required in all installations
but is provided as an optional feature for
those customers who wish to mount the
remote handset to the wall.
To install the holder to the wall,
fi
nd a
convenient location and use the hardware
provided with the kit. See the diagram below
for required hardware and con
fi
gurations.
Note that the holder can be installed at the
base of a light switch plate.
IMPORTANT
. The location of the remote
control handset is important to assure proper
temperature regulation. To obtain a constant temperature, we recommend that the handset should be between 3
and 15 feet away from the appliance
but not directly above it
. We also advise that the handset should be located
away from any other heat source and not in direct sunlight as this may a
ff
ect the temperature sensor located in the
remote handset.
Installation
Check Operation
Turn the
fi
replace
fl
ame up and down using the
remote control to con
fi
rm that the full range of inputs
is achieved—see the remote control operation
instructions on pages 8–9.
Adjust Aeration (if necessary)
Light the
fi
re and allow the unit to warm up for 10–15
minutes to evaluate the
fl
ame picture. Burners are
equipped with an adjustable shutter to control primary
aeration. See the
fi
gures below. The shutters are
factory-set to an aeration gap which will give optimum
performance for the vast majority of installations.
Depending of fuel bed used, altitude and other
considerations, the
fl
ame picture may be improved by
adjusting the aeration. The need for adjustment should
be determined only by operating the appliance with the
fuel bed and window installed and evaluating the
fl
ame
picture after a 15-minute warm-up.
Increasing aeration (open)
will cause the
fl
ames
to appear more transparent and blue showing more
ceramic e
ff
ects glow.
Decreasing aeration (close)
will cause the
fl
ames to
appear more yellow or orange showing less ceramic
e
ff
ects glow.
Too little aeration may result in black carbon
forming and dropping into the
fi
rebox.
Air Shutters
QUALIFIED
INSTALLER
30
