Valor 739-72JLN, Инструкция по установке и эксплуатации

Страница: 8 / 38

8
Using the Remote Control
Radio Frequency
315 MHz for USA and Canada.
This device complies with Part 15 of the FCC Rules and
with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
NOTE: Before using the remote control system for
the ȴ rst time, the receiver and the handset must
be synchronized. See the section Synchronize Remote
Control .
IMPORTANT: BEFORE YOU BEGIN, please note that on
this system, the settings of time/temperature can only be
programmed when the function display is ȵ ashing .
Be patient when programming as it can take a few seconds
to set.
To communicate, the handset should be within 15
b
feet
(4.5 meters) of the ȴ replace.
Do not leave the handset on the mantel or hearth.
OFF
(turns the burner
DQGWKHSLORWR΍
/DUJHȵDPHEXWWRQ
ȵDPHVXS
VHWVKRXUV
6PDOOȵDPHEXWWRQ
ȵDPHVGRZQDQGR΍
VHWVPLQXWHV
Current
temperature
(F or C)
Current time
(12 or 24 hour clock)
Handset
sensor
Battery status
Turn Fireplace ON
Press + buttons until you hear a
short beep; release buttons.
Beeping continues until pilot is lit.
NOTES:
On the valve, MAN button must be at
ON, in full counter-clockwise position
.
ON/OFF switch (if equipped) must be in I (ON) position.
Turn Fireplace OFF
Press button.
When pilot is just turned o
΍
, wait 2
minutes to light it again.
Standby Mode (Pilot Flame)
Press and hold to set ȴ replace
to pilot.
Adjust Flames Height
With pilot lit, press and hold buttons:
= increase ȵ ame height
= decrease ȵ ame height or
set to pilot
For
ȴ ne adjustment, tap buttons.
Set the di
΍
erent parameters when
they are ȵ ashing.
OWNER’S
INFORMATION