Installation
Install Battery Holder
The batteries that power the receiver need to be
installed and placed prior to synchronization and use.
1. Take the receiver from under the
fi
rebox.
2. The battery holder and cable are supplied with
the appliance. Insert 4 x 1.5V high quality alkaline
batteries in the battery holder and 1 9V battery in
the remote handset.
3. Connect the cable to the receiver.
4. Connect the other end of the cable to the battery
holder.
5. Place the receiver and battery holder as shown
under the
fi
rebox, to the right of the control valve
(placement may vary with installed options).
6. Use a heat resistant tie to gather any extra cable
between the receiver and the holder.
Battery holder
CAUTION
DO NOT
let the cable touch the burner plate above, it
will melt during operation.
Synchronize Remote Control
The receiver and the handset of the remote control
system must be initially synchronized before the
fi
rst
use.
7. With a thin object, press and hold the receiver’s
reset button until you hear one short and one long
beep. Release the button after the second beep.
8. Within the subsequent 20 seconds, press the small
fl
ame button ( ) on the remote handset until you
hear two short beeps con
fi
rming the synchronization
is set.
This is a one time setting only and is not required when
changing the batteries in the remote handset. The
remote control system is now ready to use.
QUALIFIED
INSTALLER
29
