23
23
Liner Panels Installation
All liner panels can be installed as indicated below.
Unpack the liners carefully to avoid scratching or
damaging them.
1. Place the rear panel against the back of the
fi
rebox
on the ledge of the rear log support. Make sure the
bevel part is at the top.
2. Hold the left hand side panel at an angle and insert
its bottom edge inside the
fi
rebox. Rotate the panel
to a vertical position ensuring that the top edge is
behind the
fl
ange of the
fi
rebox. Pull the panel as
forward as possible against the left edge of the
fi
rebox.
3. Hold the right hand side panel at an angle and insert
its bottom edge inside the
fi
rebox. Rotate the panel
to a vertical position ensuring that the top edge is
behind the
fl
ange of the
fi
rebox. Pull the panel as
forward as possible against the right edge of the
fi
rebox.
4. Insert the top panel over the left side panel while
holding the top panel forward up the slope. Rotate
the right side of the top panel upwards and place it
over the top of the right panel. Slide the top panel
down the slope of the
fi
rebox as far as possible to
close the gap with the rear panel and to maximize
the gap above the front edge of the top panel.
