30
30
Owner’s Information
Thermostatic Remote
Control
Wall Switch
CAUTION
DO NOT USE
a screwdriver or other metallic object
to remove the batteries from the receiver or the
handset! This could cause a short circuit to the
receiver.
CAUTION
To avoid short-circuit to the receiver, position the
antenna
so that it
DOES NOT TOUCH the ignition
wire.
Batteries
Low battery signal: see page 34.
BEFORE changing the batteries, turn off the valve
using the wall switch’s On/Off button
.
The appliance uses four 1.5 V AA alkaline batteries for
its remote control receiver and one 9 V alkaline battery
for its handset. The batteries should last one to two
seasons, depending on usage. Removing the batteries
in the off-season will extend the battery life. Should the
batteries loose power, the control may be operated by
manually turning the control knob at the valve or by
turning off the valve at the switch.
To replace the batteries in the remote control
receiver
:
1. The receiver is located to the left of the valve and it
is retained to the
fi
rebox by a
Velcro
tab. Grab the
receiver and pull it out from its location.
2. Slide and remove the receiver cover.
3. Replace the 4 AA batteries.
4. Replace the cover.
5. Put the receiver back in its position pushing it in so it
attaches to the
Velcro
tab.
Fireplace Control Devices
There are two ways to control your
fi
replace.
1. Thermostatic Remote Control
2. Wall Switch
The Thermostatic Remote Control can be programmed
to function automatically—see pages 31–34.
The Wall Switch can be used to turn on, off, and to
increase or decrease the
fl
ame height.
Please note that the remote control in the AUTO mode
will override the wall switch.
If you decide to only use the wall switch and not
use the remote control, remove the battery from the
handset and store it away.
If you plan not to use your
fi
replace for a prolonged
period of time, remove the battery from the remote
handset and turn off the gas valve using the wall
switch.
Servicing
If any attention is required for your appliance, contact
your supplier quoting the model number. It will be helpful
if the appliance’s serial number can also be quoted. This
number is on the rating plate, which is located under the
burner. The replacement parts are shown at the end of
this manual. Please always quote the part number and
description when requesting spare parts.
