10.
SWITCH FITTING
10.1.
For wall switch as only active switch
See figures 38, 39 & 40.
1.
Feed the switch wires from inside the appliance case through the
opening at the bottom right side of the heater case.
2.
Route round the back of the valve and connect the two “L” terminals
to the tabs at the left side of the control unit. See figure 38.
3.
Connect the battery holder to the
black
connection pad.
4.
If using the switch extension wires, connect the extension to the wire
harness.
5.
Fit the four 1.5 V batteries. Place the battery holder on the “Velcro”
pad in front of the battery shield. See figure 39.
6.
A standard wall switch box should be secured in the framing to
accommodate the wall switch. If the required location is over 4ft
away from the appliance, an optional #609WEK unit will be
required.
7.
When fitting the wall plate to the wall box, attach the way up shown
in figure 40 so that pressing the upper half of the switch increases
the flames.
10.2.
For active remote control with or without active wall
switch
Caution! Don’t connect the batteries in the remote control receiver until
the wires are connected to the burner control unit. A short circuit could
result in destruction of the electrical components.
1.
Feed the switch wires from inside the appliance case through the opening at
the bottom right side of the heater case.
2.
Cut off the “L” terminals from the switch wires
on the remote control receiver
and
remove insulation from approximately ¼” at ends of wires. See figure 41.
3.
Securely connect the wires to the terminal block. Connect the black wire to the terminal
opposite the brown wire. Connect the wire with the white stripe to the terminal opposite
the yellow wire. See figure 42.
4.
Route the harness wires with the “L” terminals round the back of the valve and connect
to the tabs at the left side of the control unit.
5.
Remove the remote control receiver lid. Remove the cover from the
white
connection
pad. Fit this connection pad to the remote control receiver terminals. See figure 43.
6.
Fit the
black
connection pad to the battery holder. Fit four 1.5V batteries. See figure 43.
7.
Place the batteries and connection pad in the receiver box and replace the lid.
8.
Fit the 9V battery to the handset transmitter.
9.
Place the remote control receiver on the “Velcro” pad in front of the battery shield. See
figure 44.
10.
If using the switch extension wires, connect the extension to the wire
harness.
11.
If using the wall switch, attach the wall plate
the way up shown in figure 40 so that pressing
the upper half of the switch increases the
flames.
Figure 44 Remote control
reciever position
Figure 43
Figure 42
Figure 41
Figure 40 Wall switch
orientation
Figure 39 Battery position
Figure 38 Switch wires installation
Содержание 534AN
Страница 16: ...16 Figure 19 Pack contents...
