Valor 534AN, Инструкция по установке и эксплуатации

Страница: 19 / 29

19
7.6. Top Heat Shield & Stand-off Fitting
See figures 25 & 26.
1.
If installing appliance with top vent outlet remove the plate covering the
vent hole in the top heat shield by unscrewing four screws. If installing with
rear vent outlet, the plate must remain covering the hole.
2. Remove the screws at the top rear corner of the case sides.
3. If top vent outlet, locate the heat shield over the vent pipe adapter.
4. Support the front of the shield on the two angle supports.
5. Secure the shield to the case sides by refitting the two screws at the top rear
corners and by two screws from the pack fitted near the front.
6. Bend the two top rear stand-offs and fit to the heat shield with three screws
each – see figure 26.
7.7. Support Angle Fitting
See figure 27
The distance from the wall angles to the front face of the heater case is adjustable
between
3
/
8
” (10mm) and 1
3
/
16
” (30mm) to allow for a range of wall finish
material thicknesses (e.g. tile etc).
1.
Fit the top angle support to the case top with three screws.
2. Fit the two side angle supports with two screws each. Fit the screws from
inside the heater case.
Figure 27 Support angles
Figure 26 Top & rear Stand-offs
Figure 25 Heat shield
(Shown for top vent outlet)