52
CAUTION
Do not run the switch wire over the top of the
fi
rebox.
Route the wire so it does not contact the
fi
rebox.
Install Remote Battery and Wall Switch
Kit RBWSK (required)
The Remote Battery and Wall Switch Kit is provided
with this appliance. It is connected to the receiver in the
fi
replace.
Material required
• 4 AA 1.5V alkaline batteries supplied with the engine
• Remote Battery and Wall Switch Kit, which contains:
◊
1 Wall Switch
◊
2 Screws
◊
1 Battery Holder
◊
1 Plate with magnets
◊
1 Battery Cover assembly
◊
1 Harness assembly - 25 ft
◊
1 Junction Box
◊
1 Cover plate and Screws
◊
1 Cable tie
Installation
The receiver is located on the left side of the appliance,
left of the control valve behind the appliance’s front
panel. It is maintained in position with
Velcro
bands.
1. Pull out the receiver from its location to connect the
battery holder and wall switch.
2. Feed the ‘white connector end’ of the harness
assembly through side holes in
fi
replace liner body
to receiver. Ensure suf
fi
cient harness length to
allow for removal of receiver. Note - coil up any
extra harness at
fi
replace end.
3. Connect switch to auxillary 5-pin junction and
power connection to jack.
Installation
4. Run harness assembly to mounted position of
junction box, securing harness to framing using
insulated staples (not included)
5. Feed harness assembly through a restrain on
rear of junction box, feeding through until harness
sheath is pinched by retainer and providing
suf
fi
cent length to make connection to rear of
switch and battery holder.
6. Secure junction box to the mounting surface using
appropriate fasteners (not included)
7. Align molex connection on switch cable of harness
assembly and connect to switch.
QUALIFIED
INSTALLER
