Valor 1700JN, Инструкция по установке и эксплуатации

Страница: 7 / 64

7
Owner’s Information
WARNING
CHOKING HAZARD! Ensure that the fi replace
area is clear of fi re glass, vermiculite or shale
particles as these could be ingested by small
children. Vacuum thoroughly around the
fi replace
area after cleaning.
Clean the concrete trim by dusting down the surface
regularly with a soft brush and occasionally follow up
with a wipe over with a wet cloth. A sealer has been
applied to the surface, no alcohol/solvent based clean-
ing agents nor polishes should be used. Dry stains can
be removed using a white or light colored cloth with mild
soap and warm water when the material is cool, then
dried immediately. If the stain is hard to remove, use a
white or light colored synthetic scrub pad (not steel wool)
and dry immediately. In case of an accidental spill, soak
up the liquid
IMMEDIATELY with a dry cloth and follow
up with a wipe down with a wet cloth.
Clean the barrier screen dusting it with a soft brush.
Clean the fi rebox ceramic logs/rocks and walls dust-
ing them with a soft brush. Dust can also be removed
from the burner using a soft brush after removing the
ceramic logs.
When cleaning, make sure that no par-
ticles are brushed into the slots of the burner.
To re fi t the window:
1. Place the window in its bottom railing. Ensure to
remove any vermiculite, glass or shale particles
in the railing before installing the window.
2. Push the top
of the window
frame against the
fi rebox.
!
Window frame
Bottom railing
3. While you hold it, pull and hook the side levers back
to the window brackets on each side.
4. Apply fi rm hand pressure around the window frame to
ensure the window is sealed tight against the fi rebox.
1
2
3
WARNING
Failure to install the window correctly can
leak carbon monoxide, affect the performance
of the
fi replace, damage components, cause
overheating resulting in dangerous conditions.
Damage caused by incorrect window installa-
tion is not covered by the Valor warranty.
!
DANGER
The window unit must be correctly installed,
fastened and sealed after servicing or serious
bodily injury and/or damage to the appliance
may result.
To ensure a safe operation:
•
Double-check that the bottom of the window
frame is correctly installed in the bottom
support railing;
•
Verify that the levers are hooked properly to
the window tabs then;
•
Pull out the top of the window and release it
to insure the springs return it;
• Ensure the window is sealed before operation.
!
OWNER’S
INFORMATION