Valor Fires 954, Инструкция для установщика и владельца

Страница: 35 / 64

11.6 Fitting the ‘Chic’ and ‘Envy’ front fascia.
1. Remove the packing from the fascia.
2. The lower fascia section is held in place
with magnets. Hold the sides of the lower
fascia and pull gently forward to remove.
3. A ‘Hole in the wall’ baffle is supplied with
‘Chic’ models. In elevated installations this
baffle will reduce the visibility of the sealing
tape. If required, locate the baffle as in figure
31.
4. Fit the fascia to the appliance by locating
the top to the upper hanging brackets (Figure
25), then attaching it to the body of the
appliance using the two screws supplied. If
using the ‘Hole in the wall’ baffle, place the
fascia brackets over the baffle and secure
using the two screws for securing the fascia
(See Figure 27).
5. Connect the control linkage to the control
pivot plate using the shouldered screw
previously removed and using a screwdriver
(NOT finger tight only) (See figure 29).
6. Chic model only - Supplied in the
fascia pack are two tubular trim sets. Hang
one set at the top of the fascia and the
other at the bottom (See figure 32).
6. Envy model only - Locate the lower
section of the fascia onto the tabs as
shown in figure 33.
Page 35
©
Baxi Heating U.K. Limited 2010.
INSTALLER GUIDE
Figure 31. Baffle fitting (Shown
without burner for clarity)
Figure 30. Control position label
Figure 29. Shouldered screw.