Valor Fires 844, Инструкция для установщика и владельца

Страница: 15 / 28

Fitting the brackets to the heater.
1.
Secure the spacer frames to the heater as in steps 1 and 7 of METHOD D (See
figure 9).
2.
The Elevated Installation kit
contains two wall mounting
brackets and one lower bracket.
Secure one of the wall mounting
brackets to the rear of the heater
using two of the No.8 x 3/8
screws supplied. Ensure that the
bracket is correctly orientated
before securing (See figure 11).
3.
Secure the lower bracket to
the rear of the heater using one
of the No.8 x 3/8 screws
supplied (See figure 12).
4.
Hang the heater body on the
wall hanging bracket.
5.
Underneath the heater, mark
on the wall the position of the
hole in the lower support
bracket.
6.
Lift the heater off the
wall.
7.
Drill the marked position
using a suitable sized
masonry drill bit for the wall
plugs supplied.
8.
Insert the wall plug.
9.
Hang the heater body on
the wall hanging bracket.
Secure the bottom of the
heater using a wood screw
(See figure 3).
Page 15
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2009.
Figure 12
Figure 11