Valor Fires 844, Инструкция для установщика и владельца

Страница: 14 / 28

Method E - Wall mounting with the optional spacer frame kit ( 0584081)
and Elevated Installation kit supplied in kit ( 0584091) .
The Optional Spacer Frame and Elevated Installation kit are required where a wall
mounted installation is required (Not applicable on Regalia model).
(The Classica fascia has been designed for traditional installations where the base of
the fascia sits on a hearth or similar surface. For this reason we do not recommend
the Classica model for wall mounting).
Fitting a wall mounting bracket to the wall.
When wall mounting your heater we recommend that the heater be mounted no more
than 240mm from the floor. To achieve
this, the hole centres in the wall
mounting bracket must be no more than
700mm from the floor (See figure 10).
Mounting the heater above this may
affect the visual appearance of the fuel
effect.
If fitting to a conventional brick wall then
use the outer slotted holes in the
bracket. If fitting to a
plasterboard wall
that has a wooden frame behind it then
use all four fixing holes in the bracket.
This is required to spread the load.
If the wall plugs supplied are not
satisfactory, purpose made plasterboard
fixings can be purchased from DIY
outlets.
1.
Mark the positions of the hanging
bracket holes on the wall. We recommend the use of a spirit level to ensure that the
bracket is level.
2.
Drill the marked positions using a suitable sized masonry drill bit for the wall plugs
supplied.
3.
Insert the wall plugs and secure the bracket to the wall using wood screws (See
figure 3).
Page 14
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2009.
Figure 10