Valor Fires 824 Blenheim Longlite, Инструкция для установщика и владельца

Страница: 10 / 32

6. FITTING THE FIREFRONT
General notes to read before fitting your firefront.
The installation of this firefront requires a reasonable level of DIY skills.
Please read this guide thoroughly before commencing installation and if in
doubt, seek help from a competent person.
Important: Before continuing with the installation of this firefront please ensure
that you have completed the information on the last page of this guide.
There should be at least 50mm clearance between the top of the fascia and anything
such as a shelf, fireplace surround or mantel etc. This will allow the fascia to be lifted
off or removed during servicing. To check the shelf clearance gently place the fascia
against the surface to which it is to be fixed and measure the distance from the top of
the fascia.
Do I need any tools?
Y
ou will need a Pozidrive / Phillips / cross head screwdriver. This should have a
number 2 size tip.
Where can I fit the firefront?
This firefront can be fitted into fireplaces or surrounds where the following dimensions
are available.
Width 400mm - 450 mm (15.35 inches - 17.72 inches)
Height 555mm - 590 mm (21.9 inches - 23.2 inches)
Depth At least 25mm (At least 3 inches)
* An optional spacer frame kit is obtainable either from your firefront supplier or direct
from Valor Fires Sales. The kit is a 50mm spacer kit (Kit number 5135632).
Moving the cable guide.
At the base of the firefront you will find an electric cable which runs through a
rectangular plastic cable guide. As supplied the cable guide is fitted into the
rectangular cut-out on the right side of the firefront. If required, the cable guide can be
removed and put in the rectangular slot in the centre or left hand side of the firefront.
For removal and fitting please see the following sections.
Page 10
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2010.