Valor Fires 823, Инструкция для установщика и владельца

Страница: 13 / 20

Fitting the diffuser.
The heater is supplied with a diffuser
(See figure 1).
1.
Locate the diffuser on the ledge immediately
below the screen (See figure 9).
Fitting the Fascia
Before fitting the fascia complete the last
page of this guide.
1.
Remove the fascia from its packaging.
2.
The heater is supplied with a coal support
(See figure 1). Fit this to the fascia as shown in
figure 10.
2.
Locate the fascia onto the heater. To do this
locate the bracket at the top of the fascia over
the brackets on top of the front spacer (See
figure 11).
3.
Secure the fascia in place using the two M5 x
10mm screws supplied. Fit these through the
holes in the base of the fascia.
Fitting the fuel effect.
1.
Place the loose coals on top of the fuel
support. It is not necessary to use all the coals
supplied.
Important notes.
1.
The coal pieces supplied
are a natural material.
Occasionally it will be
necessary to reduce the size
of the coal pieces. To do this
place them inside a plastic
bag, place on a suitable hard
surface and tap gently with a
small hammer or similar tool.
2.
The coals are for
decorative purposes only.
There is a choke risk to
young children. Make sure
they cannot gain access to
them.
Page 13
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2008.
Figure 11
Figure 10. Coal support location
Figure 9. Diffuser location