Valor fiers 757, Инструкция для установщика и владельца

Страница: 24 / 52

the fibre / wooden plugs supplied . Screw the
eyebolts into the plugs. Make sure that the bolts
are secure.
4. Place the hotbox unit close to the fireplace but
allow sufficient access into the fireplace opening
so that the cables can be threaded through the
eyebolts and returned through the back of the
hotbox. If a concealed connection is being used,
insert the hotbox into the fireplace feeding the
supply pipe through the pierced hole in the rear
grommet.
5. The hotbox has two holes at each side of the
spillage plate. Insert one end of each cable (one
cable each side) from the back through the lower
of the two holes and return the end through the upper
of the holes (See figure 22). Give the cables a pull so
that they grip against the hotbox flanges.
6. Thread the cables through the eyebolts. Return the
cables through the holes near the bottom of the hotbox
back panel (See figure 23)
(For precast or clay block
flue systems return the cables through the slotted
holes in the side of the hotbox)
.
7. Carefully lift the hotbox fully back into the fireplace
opening so that it is sealed against the fireplace front
surround.
Do not push the hotbox along its base as
this may damage the foam seal.
8. Ensure that the hotbox is correctly positioned in
the firplace opening (central). Drill a hole into the
fireplace floor through each of the two holes in the
base of the hotbox using a suitably sized masonry
drill bit for the fibre / wooden plugs supplied (See
figure 24).
9. Insert a fibre / wooden plug into each hole. Use
the fibre / wooden plugs supplied with this appliance
-
Never use plastic plugs instead of the fibre /
wooden plugs supplied . Fit a woodscrew in each
plug and tighten.
Always screw the base into position before
applying tension to the cables. This will ensure a
tight seal between the top of the hotbox and
wall.
10. Fit a cable retainer over the bottom end of each cable.
Page 24
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2007.
Figure 24. Floor fixing
Figure 23. Cable route
Figure 22. Upper cable retention