Valor fiers 757, Инструкция для установщика и владельца

Страница: 23 / 52

13. Locate the spacer frame to the rear of the hotbox
(The foam seal must be to the rear of the spacer
frame and NOT against the flanges of the
hotbox)
. Secure the spacer frame to the hotbox
using the six edge clips supplied. Position these as
in figure 20.
14. Remove any protective film from the spillage
plate.
10. HOTBOX INSTALLATION
10.1 Cable retention and floor
fixing.
1. Make sure that the relevant areas
at the fireplace back or floor are
sound enough to take the eyebolts
and screws. If these areas have
deteriorated due to prolonged use
they should be made sound with
suitable cement.
2. Drill four holes in the rear wall of
the fireplace for the fibre / wooden
plugs. The holes should be drilled
within the range of positions shown
in figure 21 using a suitably sized
masonry drill. The holes should be
equidistant each side of the centre
line of the fireplace to ensure that the
appliance finishes centrally in the
opening when tension is applied to
the cables.
3. Insert a fibre / wooden plug into
each hole. Use the fibre / wooden
plugs supplied with this appliance -
Never use plastic plugs instead of
Page 23
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2007.
Figure 21. Eyebolt positions
Figure 20. Fitting the edge clips