Valor fiers 757, Инструкция для установщика и владельца

Страница: 22 / 52

9. Supplied with the fire is a short and long
length of self adhesive foam seal. Take the
short length, peal off the adhesive backing
and stick to the underside of the hotbox (See
figure 16).
10. Supplied with the fire is a spacing frame.
This is made up of three separate pieces, a
top and two sides. The three pieces are
identified in figure 17.
11. The sides have a stepped top face. These
must be located on the inside the top piece
(See point 1 of figure 18). The tabs on the top
piece must locate on the inside of the side
pieces (See point 2 of figure 18). Secure the
two side pieces to the top piece using
two self tapping screws supplied.
Locate the screws from inside the ‘U’
channel.
12. The long length of self adhesive
foam seal needs to be fitted to the outer
rear edges of the side and top pieces of
the spacer frame. Fit it to the flanges
that do not have holes. The holes must
be placed against the rear of the fire.
Ensure that there is no gap between
the foam seals where they meet at the
top flange (See figure 19).
Page 22
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2007.
Figure 19. Fitting the foam seal
Figure 18. Fitting the foam seal
Figure 17. Assembling the spacer frame
Figure 16. Fitting the foam seal to the
base of the hotbox.