Valley Tool Vrisimo Sanitizer, Руководство пользователя

Страница: 11 / 32

Sanitizer
by
2) With the motor at low RPM engage the PTO out‐
put.
3) Slowly bring the thro le up to 540 RPM. If the
A achment produces excessive noise or vibra‐
on, disengage the PTO and shut down the Pow‐
er Unit immediately. Determine the cause of the
problem and correct it before con nuing with its
opera on.
4) A achment is ready for opera on.
Running Your Attachment
1) Determine ground speed based on terrain and
material being cut. This will typically fall within
the 0‐5 mph range.
2) Posi on skid shoes between 1/2‐3” off the
ground; skid shoes are not meant to run on the
ground.
3) The mower and skid shoes should be level with
the ground, the height of the mower can be ad‐
justed with the back gauge roller which runs
along the ground.
4) Adjust the sway bars so that there is a minimum
side slack and be sure the stabilizers are ght.
5) A ach the tractor’s top link to the “A” frame of
the a achment and adjust the top link to the ap‐
proximate desired cu ng height.
6) A ach the PTO to the tractor by pushing in on
the quick disconnect pin. Remember, the tube
end goes to the a achment and the bar end goes
to the tractor.
7) With the a achment and PTO line connected
check the drive sha through the en re li ing
range checking for binding, bo oming, uncou‐
pling or a achment contact.
Shut Down Procedure
1) When work is completed, disengage the PTO
drive and posi on it for storage or transport (See
the “Transport, Removal and Storage ” sec on for
details on proper storage). Shut off Power Unit
and set parking brake, wait for the a achment to
stop rota ng.
2) Visually inspect the PTO sha , all the bearings
and gearbox for excessive heat or leaks.
6