VALERII S&M GROUP 42285, Оригинальное руководство пользователя

Страница: 5 / 13

Insufficient flow
-Inlet sieve is clogged
-Reduced
pumping
capacity by dirty and
abrasive water
-Clean inset sieve
-Clean
pump and replace
worn-out parts
Pump switches
of after short
operating period
-Thermal cutout stops
pumps due to dirty water
-Water
too hot.
Thermal-cutout stops
pump
-Remove mains plug. Clean pump
and shaft
-Make
sure that a water
temperature of max. 35
℃
is not
exceed
Setting the ON/OFF operating point
The ON and OFF operating point of the float switch can be set by adjusting the float
switch in its latching holder.

The float switch must be installed so that the level of the ON operating point and the level of the
OFF operating point can be reached easily and with little force. To check this, place the pump in a vessel
filled with water, raise the float switch carefully by hand and then lower it again. As you do so, note
whether the pump switches on and off.

Make sure that the distance between the float switch head and the latching holder is not too small.
Proper operation is not guaranteed if the gap is too small.
Guarantee note:
Not cover by guarantee:

Destruction of rotating mechanical seal by dry running or addition of foreign bodies in water.

Blockage of running wheel through foreign bodies

Transport damage

Damage caused by unauthorized persons
Ordering spare parts
1. Please provide the following information if you need any spare parts:
2. Type of unit
3. Article number
4. Identification number
5. Number of the required spare part
Technical data
Certificate No. 0406WP004DR
Power supply 230V~50Hz
Power consumption 400Watt
Delivery rate max.. 7500l/h
Delivery height max 5m
Immersion depth max. 5m
Water temperature max. 35